2014 Latest 100% Pass Guaranteed Symantec ST0-149 Dumps (21-30)
Which two load balancing polices are supported with Dynamic Multi-Pathing (DMP)? (Select two.)
A. Weighted Paths
B. Fault Tolerance
C. Dynamic Recovery
D. Least Blocks
E. Dynamic Path Recognition
Refer to the Service Group Definition displayed below. Which server will start the SQLSG service group if a critical resource faults on Server3 and all servers have a current available capacity of 300?
Refer to the Service Group Definition displayed below. Which server will start the FileShareSG service group following a critical resource fault on Server2?
Which utility is used to obtain a full set of logs to send to support?
D. Configuration Checker
Which log file should be checked to determine why an IP resource faulted?
An administrator wants to install the Microsoft Failover Cluster Option in a Microsoft Failover Cluster where Veritas Storage Foundation for Windows is already installed. Which installation method should be used to minimize application downtime?
A. install in active nodes of the cluster first, then passive nodes
B. install in passive nodes of the cluster first, then active nodes
C. install in all cluster nodes simultaneously
D. install in all cluster nodes using repair install option
An administrator observed monitor time-outs for a newly configured resource that resulted in a resource fault. Which resource type attribute needs to be considered for Veritas Cluster Server (VCS) to change this behavior?
An administrator needs to reduce the time a resource has remained online without encountering
problems such that previous faults and restart attempts are ignored by the agent. Which agent type attribute needs to be tuned?
Support asked an administrator to collect logs for a resource type. Which attribute needs to be set?
Refer to the exhibit. The group dependencies in a three-system cluster are displayed in the exhibit. All groups are failover service groups with AutoFailOver enabled and all groups have the same SystemList and AutoStartList. What must happen for GroupA to be online on SystemC?
A. GroupB must fail over to SystemC.
B. GroupB must fail over to SystemB.
C. GroupA must fail over to SystemC.
D. GroupA must fail over to SystemB.
If you want to pass the Symantec ST0-149 exam sucessfully, recommend to read latest Symantec ST0-149 Exam Question full version.